Prentke Romich Company
http://www.prentrom.com/support/article/1567

Installing the Keyguard Frame and Keyguard

If you want to use a Keyguard or a Touchguide you must add the Keyguard Frame to your device. To do this, you must remove the handle from your device.

Remove the Handle
Remove the hanclle

Unscrew and remove the screws on either side of the handle. Lift the handle off the device.

Add the Keyguard Frame

Install bottom edge first

Slide the bottom edge of the Keyguard Frame into the strap holder slots on the bottom of your device.

TIP: If you are using a carry strap, you do not have to remove the strap connectors. The frame will fit around the post above the the connector loops.

Position frame over the strap holder slots.

Close-up of frame and one of the strap holder slots the frame fits into

Press on frame until it clicks.

Press down on top of frame until it clicks into place. Replace handle or screw in separate screws.

When the frame is in the bottom slots, the top of the frame will flop down over the top of your device. Push down on the frame top until it clicks into place.

You can now replace the handle.

If you would rather not have the handle on the device

A small bag with two extra screws in it was packed in your device box. Find this bag and remove the screws.

Place the screws in the two holes where the handle went. Tighten the screws. These screws help hold the Keyguard Frame in place and keep your device from having two holes in it.

Insert one of the Keyguard tabs into the slot for it on the Keyguard Frame.

Carefully slip the opposite tab under the Keyguard Frame and gently slide it up the frame until it locks into its slot.

To Open the Keyguard
Hook a finger in one of the holes and lift up.

Installing a Keyguard