Installing the Bluetooth Cell Phone Card in Vantage Plus
You must also have:
· Your Vantage
· A cell phone
Install the Audio Cable
Turn your device OFF before starting Installation.
Remove the memory door and battery door from the left side of the Vantage case.
Have audio cable from phone package ready to install.
The battery door catch is on the bottom of the case. To open the door, place the device face down on a flat surface. Insert a small flat-head screwdriver under the slot between the door and the catch and press down on the catch. The door will pop open. When replacing the door, put the door in first, then latch it in place.
To open the memory door, press down with your thumb or a finger and pull out on the edge (or lip) at the top of the door. To close the door, push in on the bottom part of the door.
Thread the audio cable (white connector end first) behind and through the plastic support piece. You may find it helpful to do this with a small pair of needle-nosed pliers.
When the cable is threaded through the support piece, plug the white connector end into the very small connector above the battery connector. To fit the connector plug into the jack correctly, the holes in the white connector plug should be oriented toward the bottom of the case. It is easier to plug in the connector if you unplug the Vantage battery pack first. You can also hold the connector with needle-nosed pliers, if necessary.
Insert the Bluetooth Phone CardWhen the audio cable is plugged in, find the Bluetooth Phone Card.
Insert the phone card into the PCMCIA (top) slot. (You will probably have to push the audio cable out of the way.) The end of the card with the pinholes in it goes in first. The side of the card with the Bluetooth label on it should be face up. Push the card until it snaps into place.
Plug the audio cable into the hole that you see on the end of the phone card.
Connect the New Memory Door
Connect the new memory door to the Vantage Case.
Make sure the batteries are connected, then replace the battery door.
