How do I Recalibrate the Touch Screen on my Vantage Lite?
Over time you may find that when you press keys, you don’t see what you are supposed to see; or you may notice that the icons and images on the display screen don’t seem to fit the display area as well as they once did. This is normal with a touch screen and can be easily fixed.
To Recalibrate the Display:
Note: You must be in your CORE, the Toolbox, Page or Activity to recalibrate your screen.You cannot do this from a menu.
1. On the top front of the case, press and hold the TOOLS key while you activate the #2 USER DEFINED key. (The key that was pre-programmed as the SET-UP key).
2. Release both keys.
3. You now see a message that tells you to Carefully press and briefly hold stylus on the center of the target. Repeat as the target moves around the scren.
4. With a stylus, the eraser end of a pencil or a pen cap, press on the center of the plus sign in the middle of your screen, next press on the plus in the top left corner of your screen. Press on the plus in the bottom left corner. Press on the plus in the top right corner. Press on the plus in the bottom right corner.
5. If the calibration is successful, you will see a note at the top of the screen that tells you New calibration settings have been measured. Tap the screen to register all saved data. Wait for 30 seconds to cancel saved data and keep the current setting. Tap the screen once. Your screen should now bring you to the toolbox or the screen you started from. If the timer continues to count down, tap the screen again until you see the screen change. If you do not see the note, repeat these steps.