How do I Install a New or Spanish Software Card into the SpringBoard Lite?
MEMORY TRANSFER: If you have made extensive changes to the vocabulary in
your device and you want to save it, perform an MTI before you continue with this
software update. Instructions for performing a Memory Transfer can be found here:
http://support.prentrom.com/article.php?id=541
Note: Before you begin the new software update: unplug your battery charger if it is
plugged into your device!
Gently place the SpringBoard Lite face down on a flat surface.
Unscrew the two screws that hold the battery door onto the case.
Remove the battery door. Keep the screws and the battery door nearby.
Unplug the battery pack and lift it out of the case so that it is in the same position as it was in the case.
Remove the battery door from the case by lifting it up and out.
Remove the old system software card by pulling on the piece of tape on the end of the
Card, taking note of what side is up.
Set the old card aside. Find the new software card that came with this update. Insert the
new card in the card slot as you see in the picture above. The side with the CE mark
should be facing up.
Insert the new software card all the way into the card slot.
Replace the battery pack and plug in the batteries. Push the wires down between the
battery pack and the case so the battery door will fit back on.
Reattach the screws.
Turn device on and press the reset button on the back of the device.
The device is now ready for use. You can either load your vocabulary back into the device via the Transfer Memory Menu or start programming your SpringBoard Lite.