Computer Access with the Bluetooth Switch and the Bluetooth Adapter.
To use the Bluetooth Switch with a computer you must have the PRC Bluetooth Adapter and a computer that has a USB port available. You may also need an external dual switch.
You will have to change The BTS Switch Mode to the Mode you want to use.
To change the position of the small Switch Mode switches, use a sturdy toothpick or a straightened paper clip.
Computer Access - Mouse Mode
Mouse mode allows your BTS to act as a mouse for your computer. You can move the cursor up, down, right and left as well as click and double click.
Note: Turn the Bluetooth Switch OFF before plugging in an external switch.
Switch Mode Setting
Set the Left switch to the far left and the Right switch to the far right.
What you will Need
The Bluetooth Switch
External Dual Switch
PRC Bluetooth Adapter
Computer with a USB port
Functions:
Computer Access - Keyboard 1, 2, 3 Mode
This mode allows you to use the PRC PASS program.
Note: Turn the Bluetooth Switch OFF before plugging in an external switch.
Switch Mode Setting
Set Left switch to far right and the Right switch to far right
What You Will Need:
The Bluetooth Switch
External Dual Switch
PRC Bluetooth Adapter
Computer with a USB port
PRC PASS Software on your computer
Keyboard 1, 2, 3 Mode emulates a USB keyboard for switch input into PRC PASS software.
Functions:
Computer Access - Keyboard Mode ENTER, F11, F12
Keyboard ENTER, F11, F12 Mode emulates a USB keyboard for switch input into WiViK software.
Switch action depends on how you have your WiViK program configured. Below is an example.
Note: Turn the Bluetooth Switch OFF before plugging in an external switch.
Switch Mode Settings:
Set Left switch to far right and Right switch to far left.
What You Will Need:
The Bluetooth Switch
External Dual Switch
PRC Bluetooth Adapter
Computer with a USB port
WiViK software on your computer
Functions:
Using the BTS with the Bluetooth Adapter
PRC Bluetooth Adapter
|
1. Turn the BTS OFF! Set the Mode Switches on the BTS for Mouse or one of the Keyboard Modes.
2. Plug in any external switches you may need.
3. Turn the BTS ON.
4. Wait until the green light goes out.
5. Plug the Bluetooth Adapter into the USB port on your PC. The blue LED will light and then go out.
6. Press the PAIR button on the Adapter. The blue LED should begin to blink.
7. Press the PAIR button on the BTS. The green LED should begin to blink.
8. When the BTS and the Adapter pair and connect, both LEDS should light steadily. The BTS will control the Adapter and the PC the adapter is plugged into.
9. You can now use the BTS to send signals to the computer.