How do I Charge the Bluetooth Switch?
Turn the BTS OFF and charge the battery before using the BTS for the first time
A full charge will take approximately 7 hours.
The battery will last several days between charges.
There are 3 ways to charge the BTS:
|
BTS, Charger (USA only) and USB Cable
Plug into electrical wall outlet
Plug the larger end of the USB cable unto the charger adapter. Plug the smaller end into the connector labeled 5VDS 500ma on the BTS. Plug the charger adapter into a working electrical outlet. Eventually a yellow LED on the BTS will light. When the light goes out, the battery is charged.
BTS, USB Cable and Computer |
Plug the larger end of the USB cable into the USB port on your computer. Plug the smaller end into the connector labeled SVDS 500ma 
on the BTS.
Your computer must be ON.
Eventually a yellow LED on the BTS will light. When the light goes out, the battery is charged.
BTS, USB Cable and AAC Device
Plug the larger end of the USB cable into the USB port on your AAC device. Plug the smaller end into the USB connector on your AAC device.
Eventually a yellow LED on the BTS will light. When the light goes out, the battery is charged.
ICON |
LED COLOR |
MEANING |
LOW BATTERY | Steady red
| Low battery Charge the battery soon |
DEAD BATTERY | Flashing red light for several seconds, then LED goes out.
| When flashing: battery is dying When no longer lit: Battery is dead and BTS will not work. Charge now. |
CHARGING
| Steady yellow | Yellow LED is visible at some point during charging, but not always immediately. When LED is no longer lit, charging is complete |