Transferring Memory from an Older Vantage/Vanguard to Another VT/VG
By plugging the MTI Serial VG to IBM/PC cable into the serial port on each Vanguard/Vantage, you can transfer vocabulary from one Vanguard/Vantage to another. If you do not have the cable, you can order it from PRC (part # 11819, Null Modem Cable).
To Transfer Memory from One Vanguard/Vantage to Another:
1. Plug the MTIcable into the Serial Port on the top of each Vanguard or on the side of each Vantage. (The ends of the cable are the same so it doesn't matter which end goes into the connector.)
2. Open the Toolbox on each device.
3. Activate the TRANSFER MEMORY MENU on each device. Make sure the baud rate is the same for both Vanguards/Vantages.
4. On the device that contains the vocabulary you want to transfer, (the "sending" device) , activate Save to Disk to begin the saving procedure.
5. Vanguard/Vantage will display "Looking for host computer ..."
6. On the device that is going to receive the vocabulary, activate Load Memory from Disk to start the loading procedure.
7. The transfer takes place automatically.
8. When the transfer is computer, select OK on both devices to exit
Note: The software versions of both Vantage/Vanguards must match OR the Vantage/Vanguard you are transferring your vocabulary to must have a software version greater than the software version in the Vantage/Vanguard you are transferring from, or else the memory transfer will not take place.