Why Won't my Liberator Accept Switch Input?
Assuming that you don't have a bad switch, cable, or port on the Liberator and your Selection Technique menu is set up properly, you may need to do the following reset (Called a "Warm Boot").
- Unscrew the battery pack screw one half turn, counter-clockwise.
- Slide the battery pack out until you see the battery telephone cable.
- Unplug the battery cable.
- Plug your battery charger into the battery pack.
- On your Pathfinder, hold down the OFF button.
- As you are holding the OFF button, plug the battery telephone cable back in. DO NOT let go of the OFF button.
- As you are holding the OFF button, push the ON button as well.
- In about 10 seconds you will hear a beep.
- When you hear the beep, let go of the OFF button first, and then release the ON button.
- Watch the screen, the Liberator should power up normally and show "System is Ready for Use."
- Now go to the Selection Tech Menu [I2] and select (#3) Setup switches. The switch should now be accepting input.
Note: Doing this procedure will NOT erase your memory.