How do I Transfer Memory from an AlphaTalker to a PC/IBM?
1. Remove the keyguard and overlay and open the Toolbox.
2. All memory transfers should be made with the battery charger plugged in. Connect one end of the battery charger that came with your AlphaTalker to the charging jack on the side of the case. Plug the other end of the battery charger into a working wall outlet.
3. Plug the larger rectangular end of the cable (labelled 11977) that came with your MTI program into Serial Port 1 on your computer. Plug the small round end into the connector labeled RS232 on the top of the AlphaTalker case.
4. Turn the computer On. Insert the MTI CD into the CDdrive of your computer.
5. Double click on MTI.exe. The MTI screen is visible on your computer monitor.
6. In the MTI Options menu, click on the name of the device you are using (i.e., AlphaTalker). You can also change computer serial ports here and select a baud rate if you need to.
7. To save memory to the computer: Go to the AlphaTalker Toolbox and press the SAVE MEMORY TO DISK key. If every thing is connected properly, you will see Save Memory to File on your computer screen.
8. On your computer, go to the drive/folder where you want to save the AlphaTalker 's memory.
9. Type in a name for the new file (e.g., ATMEM1). Click on Save. The transfer takes place automatically.
To Restore Memory to the AlphaTalker:
1. In the AlphaTalker's Toolbox, select the LOAD MEMORY FROM DISK key
2. On your computer, select the AlphaTalker file you want to restore (e.g., ATMEM1).
3. Click on Restore.
Please see Using the Memory Transfer Interface (MTI) Software on an IBM.
and the article Tips for a Successful Memory Transfer with an IBM Computer.