How do I Switch User Areas or Load a Different Overlay in Accent?
To Switch User Areas:
1. Go to the Toolbox screen by pressing the TOOLS button 
on the front of the Accent case.
2. When you see the Toolbox screen, press the key labeled USER AREA MENU. 
3. The user area you are currently using will be listed in the text area at the top. If you want to switch to a different User Area or to see what other areas contain, activate the Switch User Area option.
4. You now see the names of all 6 User Areas.
Select the Area you want to switch to.
IMPORTANT! If you wish to keep any of your custom vocabulary in a particular User Area, make sure you do not select that area to load a new overlay into All vocabulary that is stored in the User Area you select will be lost when the new overlay is installed!
You can also perform a Memory Transfer to save a particular Area before loading a new overlay into it. http://www.prentrom.com/support/article/1793
To load a different overlay in a User Area:
5. Activate the Replace User Area option.
6. Select the Folder of the overlay you want to load into the User Area you selected in step #4.
Blank overlays in the Replace User Area option do not contain any pre-stored vocabulary.
NOTE: If you are using WordPower, you must locate your USB Flash or SD Card that came with your WordPower folder to reload this program.
7. A warning message will now appear that says, "Are you sure you want to erase everything?" If you want to load the new overlay, select YES. If you decide you don't want to load the overlay, select NO to exit. Type the word replace. Please Wait will appear.
8. Activate OK twice when the overlay is finished loading. Now select GO TO HOME to view your new overlay or start programming.