Using the Handle Stand and Installing a New One on Accent 700
Using the Handle StandThe Handle Stand acts as both a stand for your device and a handle for carrying it.
There are two handle positions: all the way up and all the way down.
Between the up and down handle positions there are two stand positions: a high angle and a medium angle.
How to change the Handle Stand Position
Place device face down. Pull both sides of the Handle Stand out from the case and move the Stand up or down a notch at a time until you achieve the position you want. Release the stand and push sides back into the case to stop it from moving.
|
The handle stand screws allow you to move the stand but prevent you from pulling the stand off the case.
Replacing the Handle Stand on Accent 700
1. Remove the 2 screws located on each end of the handle stand using a #1 phillips screwdriver.
2. Pull out on each side of the handle stand to remove it from the device.
3. Install the new stand by pulling apart the legs and inserting into the same holes the other stand was removed from.
4. Remove the screws and washers from the ends of the stand you just removed and install them into the ends of the new stand to securely attach the new stand to the Accent 700.