Installing the Bluetooth Card in Essence VG
Parts in the Bag:
NOTE: You will not need the new memory door that may also be in the Parts bag.
You must also have:
The Essence|VG
A Bluetooth cell phone
Plug in the Audio Cable
NOTE: Turn the Essence|VG OFF before beginning this process.
Open the memory door on the right side of the case.
Plug the white end of the audio cable into the small white connector that you can see below and to the right of the system card that is already in the Essence|VG. Make sure the pin holes in the cable connector match up with the pinholes in the VG connector. The holes on the cable connector should be toward the top of the connector. Push on the connector until you feel it click into place.
Insert the Bluetooth Phone Card
Place the phone card in Slot B (above the system card that is already in its place). The end with the pin-holes goes in first and the side with PRC on the label should be facing up as you insert the card.
To remove the card, press on the small button to the left of the card and the card will pop out about 1/8th of an inch. Pull it the rest of the way out by grasping the card in your fingers.
Plug the audio cable into the small hole that you see on the end of the phone card. You will not be able to close the door once the cable is plugged in. Wrapping the cable as shown above helps to keep it out of the way, but you do not have to do this. Just make sure the cable is securely plugged in.