How do I Erase a Core Sequence in ECO2?
To Erase a Message stored under an Icon or Icon Sequence
1. Activate the TOOLS key to go to the Toolbox.
2. Select ERASE CORE.
3. Select the icon or icon sequence of the message you want to erase.
4. Select OK. You see the warning box below:
5. Answer YES to erase or NO if you decide to keep the message.
6. The Text Display Area tells you that the sequence has been erased. If there was a Dynamic Activity linked to this core key, you will get a second warning box similar to the one that follows:
If you select YES to unlink, the last icon in your sequence will disappear from your overlay and you will no longer be able to access that particular sequence or its Dynamic Activity.
If you select NO, you do not want to unlink, the sequence itself will be erased, but the last icon in your sequence will remain visible and you will continue to be able to access its Dynamic Activity.
Note: You can also erase a message by programming over it. Select STORE CORE in the Toolbox. Instead of choosing a new icon sequence, select the sequence you want to modify, then OK. Change the programming as needed.